The Mixed-Use (MU) zones provide for mixed-use developments that permit a broad range of commercial, institutional, and multiple dwelling unit residential development at varying densities. The MU-15 through MU-22 zones specifically cover the Dupont Circle area with the intention of protecting and enhancing the unique characteristics of the neighborhood.
The purposes of the Dupont Circle Mixed-Use zones are to:
- Require a scale of development consistent with the nature and character of the Dupont Circle area in height and bulk and ensure a general compatibility in the scale of new buildings with older, low-scale buildings;
- Enhance the residential character of the area by maintaining existing residential uses and controlling the scale, location, and density of commercial and residential development;
- Protect the integrity of “contributing buildings”, as that term is defined by the Historic Landmark and Historic District Protection Act of 1978;
- Preserve areas planned as open gardens and backyards and protect the light, air, and privacy that they provide;
- Enhance the streetscape by maintaining the public space in front of buildings as landscaped green spaces and limited curb cuts on Connecticut Avenue; and
- Encourage greater use of public transportation and the free circulation of vehicles through public streets and alleys.
The MU-19 zone is intended to permit medium-density, compact mixed-use development with an emphasis on residential development
|Floor Area Ratio (max.)||Height (ft.)||Penthouse Height (ft.)/Stories||Lot Occupancy
|Rear Setback (ft.)2, 3, 4||Side Setback (ft.)||Green Area Ratio||Zoning Regulation Reference|
|MU-19||6.0||90||20 (1 story plus mezzanine)||100||15 ft.||None required; however, if a side yard is provided it shall be at least 2 in. wide for each 1 ft. of height of building but no less than 5 ft.||0.30||Subtitle G, Chapter 6|
|7.2(IZ)||70 (IZ)||Second story permitted for penthouse mechanical space||8 ft. for a single-family detached or semi-detached dwelling|
1 A horizontal plane may be established at 25 ft. above the mean finished grade at the middle of the rear of the structure for the purpose of measuring rear yard
2 Where a lot abuts an alley: (1) For that portion of the structure below a horizontal plane described in from the center line of the alley to the rear wall of the portion; and For that portion of the structure above the horizontal plane described in Subtitle G § 605.5, from the rear lot line to the rear wall of that portion immediately above the plane; and
3 Where a lot does not abut an alley, the rear yard shall be measured from the rear lot line to the rear wall of the building or other structure.