The Mixed-Use (MU) zones provide for mixed-use developments that permit a broad range of commercial, institutional, and multiple dwelling unit residential development at varying densities. The MU-15 through MU-22 zones specifically cover the Dupont Circle area with the intention of protecting and enhancing the unique characteristics of the neighborhood.
The purposes of the Dupont Circle Mixed-Use zones are to:
- Require a scale of development consistent with the nature and character of the Dupont Circle area in height and bulk and ensure a general compatibility in the scale of new buildings with older, low-scale buildings;
- Enhance the residential character of the area by maintaining existing residential uses and controlling the scale, location, and density of commercial and residential development;
- Protect the integrity of “contributing buildings”, as that term is defined by the Historic Landmark and Historic District Protection Act of 1978;
- Preserve areas planned as open gardens and backyards and protect the light, air, and privacy that they provide;
- Enhance the streetscape by maintaining the public space in front of buildings as landscaped green spaces and limited curb cuts on Connecticut Avenue; and
- Encourage greater use of public transportation and the free circulation of vehicles through public streets and alleys.
The MU-22 zone is intended to permit medium- to high-density mixed-use development with a balance of uses conducive to a higher quality of life and environment for residents, businesses, employees, and institutions.
|Floor Area Ratio (max.)1||Height (ft.)||Penthouse Height (ft.)/Stories||Lot Occupancy
|Rear Setback (ft.)2, 3, 4, 5||Side Setback (ft.)||Green Area Ratio||Zoning Regulation Reference|
|MU-22||6.0||90||20 (1 story plus mezzanine)||100||12 ft. (residential use only)||None required; if a side yard is provided no less than 12 ft.||0.20||Subtitle G, Chapter 6|
|7.2 (IZ)||100 (IZ)||Second story permitted for penthouse mechanical space||8 ft. for a single-family detached or semi-detached dwelling|
1 Combined lot development is permitted for the purposes of allocating gross floor area devoted to residential and non-residential uses in accordance with the provisions of Subtitle G § 100.4. Both lots shall be located within the same square
2 A minimum rear yard of 2.5 in. per 1 ft. of vertical distance from the mean finished grade at the middle of the rear of the structure to the highest point of the main roof or parapet wall, but not less than 12 ft.
3 A rear yard shall be established no lower than the first level of residential use;
4 Where a lot abuts an alley, the rear yard may be measured from the center line of the alley to the rear wall of the building or other structure; and
5 Where a lot does not abut an alley, the rear yard shall be measured from the rear lot line to the rear wall of the building or other structure.